Dell POWERCONNECT 5548P - Connecting the Switch to the Terminal

58 Dell PowerConnect 55xx Systems User Guide
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Maintenance Projects\Dell
Contax\CxUG_InitialConfiguration_gsg.fm
DELL CONFIDENTIAL – PRELIMINARY 9/11/12 - FOR PROOF ONLY
Configuration Work Flow
To configure the switches:
1
For each switch in the stack:
a Connect it to a terminal, as described in the "Connecting the Switch
to the Terminal" on page 59.
b Boot the switch, as described in the "Booting the Switch" on page 60.
c Assign a unit ID to the switch, as described in "Assigning Unit IDs" on
page 50.
2 Connect the units in the stack to each other, as described in "Configuring
the Stack" on page 61.
3 Connect the Master unit to the terminal, reboot the unit and the Setup
Wizard is run automatically, as described in "Configuration Using the
Setup Wizard" on page 61.
4 Respond to the Setup Wizard prompts.
5 Continue managing the switch, either through the console or Telnet, using
the CLI or the web GUI.