Dell POWERCONNECT 5548P - Page 234

Dell PowerConnect 55xx Systems User Guide 233
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Maintenance Projects\Dell
Contax\CxUGSystemConfig.fm
DELL CONFIDENTIAL – PRELIMINARY 9/11/12 - FOR PROOF ONLY
The following is an example of a CLI script to create a tunnel:
tunnel isatap query-interval
seconds
no tunnel isatap query-interval
Configures the interval between DNS
Queries (before the IP address of the
ISATAP router is known) for the
automatic tunnel router domain
name.
Use the no form of this command to
restore the default configuration.
tunnel isatap solicitation-
interval seconds
no tunnel isatap solicitation-
interval
Configures the interval between
ISATAP router solicitations messages
(when there is no active ISATAP
router).
Use the no form of this command to
restore the default configuration.
tunnel isatap robustness number
no tunnel isatap robustness
Configures the number of DNS
Query/Router Solicitation refresh
messages that the device sends.
Use the no form of this command to
restore the default configuration.
show ipv6 tunnel Displays information on the ISATAP
tunnel.
Table 9-30. ISATAP Tunnel CLI Script
CLI Command Description
console#config Enter Global Configuration
mode.
console(config)# interface vlan 1 Enter Interface mode for
VLAN 1.
console(config-if)# ip address
10.5.225.40 /27
Configure an IP address with
prefix length of 27.
console(config-if)# ip default-gateway
10.5.225.33
console(config-if)#exit
Set the address of the default
gateway and exit Interface
mode.
Table 9-29. ISATAP Tunnel CLI Commands (Continued)
CLI Command Description