Dell POWERCONNECT 5548P - Page 66

Dell PowerConnect 55xx Systems User Guide 65
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Maintenance Projects\Dell
Contax\CxUG_InitialConfiguration_gsg.fm
DELL CONFIDENTIAL – PRELIMINARY 9/11/12 - FOR PROOF ONLY
12 Enter the default gateway.
13 Press Enter . The following is displayed (example):
This is the configuration information that has
been collected:
SNMP Interface = "Dell Network
Manager"@192.168.2.10
User Account setup = admin
Password = **********
Management IP address = 192.168.2.100
255.255.255.0
Default Gateway = 192.168.2.1
The following information is displayed:
If the information is correct, please select (Y)
to save the configuration and copy to the start-up
configuration file. If the information is
incorrect, select (N) to discard configuration and
restart the wizard: [Y/N]
14
Enter [N] to restart the wizard or enter [Y] to complete the Setup Wizard.
If you enter [Y] the following is displayed:
Configuring SNMP management interface.
Configuring user account.......
Configuring IP and subnet......
Thank you for using Dell Easy Setup Wizard. You
will now enter CLI mode.
The CLI prompt is displayed. You have finished the initial configuration.
After the initial configuration is complete, you can manage the switch from
the connected console port using the CLI or remotely through the
management interface, using Telnet or the Web GUI. See the
Dell
PowerConnect 5500 Series User Guide
found on the Documentation CD.