Recommended tools
You need the following tools to perform the removal and installation procedures:
• Phillips #1 screwdriver
• Phillips #2 screwdriver
• 1/4 inch at head screwdriver
• Wrist grounding strap
• ESD mat
Inside the enclosure
CAUTION: This system must be operated with the system cover installed to ensure proper cooling.
Figure 13. Inside the C6400 enclosure
1
sled (4) 2 right midplane
3 fan cage (2) 4 fan (4)
5 right linking board 6 backplane
7 drive cage 8 expander board
9 left midplane 10 left linking board
11 chassis management board 12 power interposer board
Dell PowerEdge C6400 Installation and Service Manual
Installing and removing enclosure components
33
To Next Page
Loading...
