Figure 25. Removing a power supply unit
Next steps
Install the PSU.
Related links
Installing a power supply unit
Installing a power supply unit
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 For systems that support redundant PSU, ensure that both the PSUs are of the same type and have the same maximum output
power.
NOTE
: The maximum output power (shown in watts) is listed on the PSU label.
Steps
Slide the PSU into the system until the PSU is fully seated and the release latch snaps into place.
44
Dell PowerEdge C6400 Installation and Service Manual
Installing and removing enclosure components
To Next Page
Loading...
