Dell PowerEdge C6400 - Installing the Power Interposer Board (PIB)

Figure 37. Removing the midplane power cables from the PIB
Next steps
Install the PIB.
Related links
Removing a power supply unit
Installing the power interposer board
Installing the power interposer board
Prerequisites
WARNING
: Allow the power interposer board (PIB) to discharge after you power o the system. Handle the PIB by the edges
and avoid touching the contact surfaces of the connectors.
1 Follow the safety guidelines listed in Safety instructions.
Steps
1 Using the Phillips #2 screwdriver, replace the screws that secure the midplane power cable to the PIB.
Dell PowerEdge C6400 Installation and Service Manual
Installing and removing enclosure components
55