Figure 48. Removing the right midplane
Next steps
Install the right midplane.
Related links
Removing a sled
Removing the cooling fan cage
Installing the right midplane
Installing the right midplane
Prerequisites
NOTE
: You must route the cables properly on the chassis to prevent them from being pinched or crimped.
1 Follow the safety guidelines listed in Safety instructions.
Steps
1 Using the Phillips #1 screwdriver, connect and secure the power cables to the midplane.
2 Place the midplane into the chassis.
3 Using the Phillips #1 screwdriver, tighten the screws that secure the midplane to the chassis.
64
Dell PowerEdge C6400 Installation and Service Manual
Installing and removing enclosure components
To Next Page
Loading...
