Figure 28. Installing the system cover
Next steps
1 Reconnect the system to the electrical outlet.
2 Turn on each sled in the system, including all the attached peripherals.
Backplane cover
Removing the backplane cover
Prerequisites
NOTE
: This procedure is not applicable for enclosures with the 3.5 inch hard drive conguration.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Steps
1 Using the Phillips #1 screwdriver, remove the screws that secure the backplane cover to the enclosure.
2 Slide the backplane cover toward the back of the enclosure and lift the cover away.
Dell PowerEdge C6400 Installation and Service Manual
Installing and removing enclosure components
47
To Next Page
Loading...
