Figure 32. Installing a cooling fan
Next steps
1 Follow the procedure listed in After working inside your system.
2 Check the management software to see if the fan is rotating at the optimal speed.
Removing the cooling fan cage
Prerequisites
WARNING
: Do not attempt to operate the system without the cooling fans.
WARNING: The cooling fan spins for some time after the system is powered down. Allow the fan to stop spinning before
removing it from the system.
NOTE: Observe the routing of the cables when removing them from the system. Route these cables properly when you replace
them to prevent the cables from being pinched or crimped.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the cooling fans.
Steps
1 Disconnect the fan power cable from the chassis management board.
2 Lift the cooling fan cage out of the chassis.
Dell PowerEdge C6400 Installation and Service Manual
Installing and removing enclosure components
51
To Next Page
Loading...
