Steps
1 Orient the drive cage so that the drive bays are facing down.
2 Place the backplane on the drive cage, aligning the screw holes on the backplane with the holes on the drive cage.
3 Using the Phillips #2 screwdriver, replace the screws to secure the backplane to the drive cage.
Figure 62. Installing the backplane
Next steps
1 Reconnect all the disconnected cables.
2 Install the drive cage into the enclosure.
3 Follow the procedure listed in After working inside your system.
Related links
Installing the 2.5 inch drive cage
76
Dell PowerEdge C6400 Installation and Service Manual
Installing and removing enclosure components
To Next Page
Loading...
