11. Lift the right edge of the I/O board upwards to disengage the connector and
remove from the system.
Installing The Input/Output Board
1. Place the Input/Output (I/O) board on the system and ensure the connector
is properly engaged to the matching connector on the system board.
2. Tighten the single screw securing the I/O board in place.
3. Connect the ExpressCard cable.
4. Install the
palm rest
.
5. Install the
hard drive
.
6. Install the
optical drive
.
7. Install the
keyboard
.
8. Install the
keyboard trim
.
9. Install the
base cover
.
10. Install the
battery
.
11. Follow the procedures in
After Working Inside Your Computer
.
70
To Next Page
Loading...
