Dell Remote Access Controller 4 Firmware Version 1.30 - Getractime; Synopsis; Description; Output

racadm Subcommand Man Pages 163
getractime
NOTE: To use this command, you must have Log In DRAC 4 permission.
Ta bl e A-17 describes the getractime subcommand.
Synopsis
racadm getractime [-u] [-d]
Description
The getractime subcommand displays the time in one of the following two formats:
• u — The UTC hexadecimal value followed by the offset in signed decimal (default).
•d — The
yyyymmddhhmmss.mmmmmms off string with no option is displayed in the same
format as the UNIX
®
date command.
Output
The getractime subcommand displays the output on one line.
ifconfig
NOTE: To use this command, you must have Execute Diagnostic Commands or
Configure
DRAC 4 permission.
Ta bl e A-18 describes the ifconfig subcommand.
Synopsis
racadm ifconfig
Table A-17. getractime
Subcommand Definition
getractime Displays the time from the controller.
Table A-18. ifconfig
Subcommand Definition
ifconfig Displays the contents of the network interface table.