Dell Remote Access Controller 4 Firmware Version 1.30 - Cfgserialconsolenoauth (Read;Write); Cfgserialconsolecommand (Read;Write); Cfgserialhistorysize (Read;Write)

202 DRAC 4 Property Database Group and Object Definitions
www.dell.com | support.dell.com
cfgSerialConsoleNoAuth (Read/Write)
NOTE: To modify this property, you must have Configure DRAC 4 permission.
Legal Values
0 – Login prompt is Enabled on the serial shell.
1 – Login prompt is Disabled on serial shell.
Default
0
Description
Allows you to disable authentication on the serial shell.
cfgSerialConsoleCommand (Read/Write)
NOTE: To modify this property, you must have Configure DRAC 4 permission.
Description
The serial command runs after login at the start of a session and allows you to set up a
command such as connect com2 that autoruns when a session begins.
Default
Empty string (no command).
Example
connect com2
cfgSerialHistorySize (Read/Write)
NOTE: To modify this property, you must have Configure DRAC 4 permission.
Legal Values
Any integer less than or equal to 8192. (If a value larger than 8192 is supplied, no error is
returned and the history size is set to 8192.)
Default
8192 characters
Description
Sets the size of the serial history buffer.