Dell Remote Access Controller 4 Firmware Version 1.30 - Cfgnettuningipsubnetsarelocal (Read;Write); Tuning the DRAC 4 for Satellite Connectivity; DRAC 4 Properties for Satellite Connectivity

208 DRAC 4 Property Database Group and Object Definitions
www.dell.com | support.dell.com
cfgNetTuningIpSubnetsAreLocal (Read/Write)
NOTE: To modify this property, you must have Configure DRAC 4 permission.
Legal Values
1 or 0
Default
1
Description
Packets addressed to subnets of the local net do not go to the gateway.
Tuning the DRAC 4 for Satellite Connectivity
The racadm CLI may be used to modify the network tuning properties of the DRAC 4. It is also
possible to use the racadm.cfg file to modify these properties (similar to the manner in which
.ini files are used).
racadm config -g cfgNetTuning -o cfgNetTuningNicMtu < value >
racadm config -g cfgNetTuning -o cfgNetTuningIpTtl < value >
racadm config -g cfgNetTuning -o cfgNetTuningIpReassTtl < value >
racadm config -g cfgNetTuning -o cfgNetTuningTcpSrttBase < value >
racadm config -g cfgNetTuning -o cfgNetTuningTcpSrttDflt < value >
racadm config -g cfgNetTuning -o cfgNetTuningTcpReXmtMin < value >
racadm config -g cfgNetTuning -o cfgNetTuningTcpReXmtMax < value >
racadm config -g cfgNetTuning -o cfgNetTuningTcpMsl < value >
where <value> is obtained from Table B-2.
Table B-2. DRAC 4 Properties for Satellite Connectivity
Property Normal Value Satellite Value
cfgNetTuningNicMtu 0x5dc 0x1f4
cfgNetTuningIpTtl 0x40 0x80
cfgNetTuningIpReassTtl 0x3c 0x78
cfgNetTuningTcpSrttBase 0 0x100
cfgNetTuningTcpSrttDflt 0x6 0x180