Dell Remote Access Controller 4 Firmware Version 1.30 - cfgNetTuning

204 DRAC 4 Property Database Group and Object Definitions
www.dell.com | support.dell.com
cfgSerialTelnet7flsBackspace (Read/Write)
NOTE: To modify this property, you must have Configure DRAC 4 permission.
Description
When enabled, the DRAC 4 will interpret 0x7f characters as backspaces from a telnet session.
Some telnet clients send 0x7f characters when you press <Backspace>. Normally, when you
press <Backspace>, 0x08 characters are sent.
Default
0
Legal Values
0=Disabled, 1=Enabled
cfgNetTuning
The group contains parameters to tune the DRAC 4 network configuration.
One instance of the group is allowed. All objects in this group require a DRAC 4 reset before
they become active. The following subsections describe the objects in this group.
cfgNetTuningNicAutoneg (Read/Write)
NOTE: To modify this property, you must have Configure DRAC 4 permission.
Legal Values
1 or 0
Default
1
Description
Enables autonegotiation of physical link speed and duplex. If enabled, autonegotiation takes
priority over values set in the cfgNetTuningNic100MB and cfgNetTuningNicFullDuplex objects.
cfgNetTuningNic100MB (Read/Write)
NOTE: To modify this property, you must have Configure DRAC 4 permission.
Legal Values
1 or 0