Dell Remote Access Controller 4 Firmware Version 1.30 - Enabling the Serial;Telnet Console Locally

48 Configuring the DRAC 4 to Use a Serial or Telnet Text Console
www.dell.com | support.dell.com
Enabling the Serial/Telnet Console on the DRAC 4
You can enable the serial/telnet console locally or remotely.
Enabling the Serial/Telnet Console Locally
NOTE: You (the current user) must have Configure DRAC 4 permission in order to perform the steps in
this section.
To enable the serial/telnet console from the managed system, type the following local racadm
CLI commands from a command prompt.
NOTE: For detailed information about how to use the racadm CLI, serial/telnet, and racadm commands,
see "
Using the serial and racadm Commands."
racadm config -g cfgSerial -o cfgSerialConsoleEnable 1
racadm config -g cfgSerial -o cfgSerialTelnetEnable 1
Table 3-3. Sample File: /etc/securetty
vc/1
vc/2
vc/3
vc/4
vc/5
vc/6
vc/7
vc/8
vc/9
vc/10
vc/11
tty1
tty2
tty3
tty4
tty5
tty6
tty7
tty8
tty9
tty10
tty11
ttyS0