Dell Remote Access Controller 4 Firmware Version 1.30 - Adding DRAC 4 Users and Privileges to Active Directory

Using the DRAC 4 With Microsoft
®
Active Directory 95
Opening the Active Directory Users and Computers Snap-In
To open the Active Directory Users and Computers snap-in, perform the following steps:
1 If you are on the domain controller, click Start Admin Tools → Active Directory Users and
Computers
. If you are not on the domain controller, you must have the appropriate Microsoft
Administrator Pack installed on your local system. To install this Administrator Pack, click
Start → Run , type MMC and press <Enter>.
This opens the Microsoft Management Console (MMC).
2 Click File (or Console on systems running Windows 2000) in the Console 1 window.
3 Click Add/Remove Snap-in .
4 Select the Active Directory Users and Computers snap-in and click Add .
5 Click Close and click OK .
Adding DRAC 4 Users and Privileges to Active Directory
The Dell-extended Active Directory Users and Computers snap-in allows you to add DRAC 4
users and privileges by creating RAC, Association, and Privilege objects. To add each type of
object, perform the steps in each subsections.
Creating a RAC Device Object
1 In the MMC Console Root window, right-click a container.
2 Select New → Dell RAC Object .
This opens the
New Object window.
3 Type a name for the new object. This name must match the DRAC 4 Name that you will type
in step 4 of "Configuring the DRAC 4."
4 Select RAC Device Object .
5 Click OK .
Creating a Privilege Object
Privilege Objects must be created in the same domain as the Association Object to which it
is
associated.
1 In the Console Root (MMC) window, right-click a container.
2 Select New → Dell RAC Object .
This opens the
New Object window.
3 Type a name for the new object.