Dell S2830dn

Remove paper from standard output bin
Remove the paper stack from the standard bin.
Standard network software error [54]
Try one or more of the following:
• From the printer control panel, press to confirm.
• Unplug the router, then wait for 30 seconds, and then plug it back again.
• Turn o the printer, and then turn it back on.
• Update the network firmware in the printer or the print server. For more information, visit the Dell
Support Web site at
http://support.dell.com contact your system support person.
Parallel port disabled [56]
• From the control panel, press to clear the message.
Notes:
• The printer discards any data received through the parallel port.
• Make sure that the Parallel Buer menu is not set to Disabled.
Standard USB port disabled [56]
Try one or more of the following:
• From the printer control panel, press to clear the message and continue printing.
Note: The printer discards any data received through the USB port.
• From the printer control panel, set USB Buer to Auto.
Too many trays attached [58]
1 Turn
o
the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra trays.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Unformatted
flash
detected [53]
Try one or more of the following:
• From the printer control panel, press to stop the defragmentation and continue printing.
• Format the flash memory device.
Troubleshooting 111