Use To
Portrait Width
3–8.5 inches
76–216 mm
Set the portrait width.
Notes:
• If the width exceeds the maximum, then the printer uses the
maximum width allowed.
• 8.5 inches is the US factory default setting. You can increase
the width in 0.01‑inch increments.
• 216 mm is the international factory default setting. You can
increase the width in 1‑mm increments.
Portrait Height
3–14.17 inches
76–360 mm
Set the portrait height.
Notes:
• If the height exceeds the maximum, then the printer uses the
maximum height allowed.
• 14 inches is the US factory default setting. You can increase the
height in 0.01‑inch increments.
• 356 mm is the international factory default setting. You can
increase the height in 1‑mm increments.
Feed Direction
Short Edge
Long Edge
Specify the feed direction if the paper can be loaded in either
direction.
Notes:
• Short Edge is the factory default setting.
• Long Edge appears only when the longest edge is shorter than
the maximum width supported in the tray.
Reports menu
Reports menu
Use To
Menu Settings Page Print a report containing information about the paper loaded in trays,
installed memory, total page count, alarms, timeouts, control panel
language, TCP/IP address, status of supplies, status of the network
connection, and other information.
Device Statistics Print a report containing printer statistics, such as supply information and
details about printed pages.
Network Setup Page Print a report containing information about the network printer settings, such
as the TCP/IP address information.
Note: This menu item appears only in network printers or in printers
connected to print servers.
Profiles List Print a list of profiles stored in the printer.
Note: This menu item appears only when LDSS is enabled.
Understanding the printer menus 54
To Next Page
Loading...
Need help?
General
