Dell S2830dn

Incorrect characters print
Action Yes No
Step 1
Make sure the printer is not in Hex Trace mode.
Note: If Ready Hex appears on the printer display, then turn o
the printer, and then turn it back on to deactivate Hex Trace
mode.
Is the printer in Hex Trace mode?
Deactivate Hex
Trace mode.
Go to step 2.
Step 2
a From the printer control panel, select Standard Network or
Network [x], and then set SmartSwitch to On.
b Resend the print job.
Do incorrect characters print?
Contact
technical
support.
The problem is
solved.
Tray linking does not work
Note: The trays and the multipurpose feeder do not automatically detect the paper size. You must set
the size from the Paper Size/Type menu.
Action Yes No
a From the printer control panel, set the paper size and type in
the Paper menu to match the paper loaded in the trays to be
linked.
Note: The paper size and type must match for trays to be
linked.
b Resend the print job.
Do the trays link correctly?
The problem is
solved.
Contact
technical
support.
Large jobs do not collate
Action Yes No
Step 1
a From the Finishing menu on the printer control panel, set
Collate to (1,2,3) (1,2,3).
b Resend the print job.
Did the job print and collate correctly?
The problem is
solved.
Go to step 2.
Troubleshooting 125