Figure 98. Top Storage Controller IPv6 Address Values
If the management network uses IPv6, configure the following IPv6 addresses:
a. Enter the IPv6 IP address in the IPv6 Address field.
b. Enter the IPv6 prefix length in IPv6 Prefix Length field.
c. Enter the IPv6 gateway address in the IPv6 Gateway field.
d. Click Continue.
If the management network does not use IPv6, click Skip IPv6 Configuration.
2. Click Add Controller. The wizard prompts you for information about the bottom storage controller.
NOTE: Information displayed in the following figure is for illustration only. The values displayed
are unique to each storage controller.
116
Set up Storage Center Software
To Next Page
Loading...
