Figure 99. Add Controller Page
3. In the Ether 0 (MGMT) Interface area, enter the IPv4 Address and IPv6 Address of the bottom storage
controller.
• The Storage Center Setup Wizard uses the HSN value in the license file as the Controller ID for
the bottom storage controller. The HSN value cannot be changed.
• The Storage Center Setup Wizard uses a predefined IP address and subnet mask for the Ether 1
(IPC) Interface. The IP address values of the Ether 1 (IPC) Interface cannot be changed.
NOTE: In the SC4020 storage system, the IPC connection between the storage controllers
is internal. The IPC connection does not require external cabling.
4. Click Continue.
The Startup Wizard displays a message that data and configuration information on the bottom
storage controller will be lost and asks for confirmation.
Set up Storage Center Software
117
To Next Page
Loading...
