Steps
1. Align the optical drive bezel to the optical drive and snap the bezel onto the optical drive.
NOTE: Start from the edge of the bezel with the smaller securing tabs and snap them into place.
2. Slide the optical drive into the hard-drive and optical-drive bracket.
3. Replace the (M2x3) screw that secures the optical drive to the hard-drive and optical-drive bracket.
Next steps
1. Install the HDD and ODD cage.
2. Install the 3.5-inch hard drive.
3. Install the front cover.
4. Install the left-side cover.
5. Follow the procedure in After working inside your computer.
Removing and installing components
23
To Next Page
Loading...
