Dell Vostro 3710 - Media-Card Reader (Optional)

Steps
1. Place the antenna modules on the chassis.
2. Align the captive screws on the antenna modules with the screw holes on the chassis.
3. Replace the two screws (M2x3) that secure the antenna modules to the chassis.
4. Route the antenna cables through the slot on the chassis and route the antenna cables through the routing guides on the
chassis.
Next steps
1. Install the wireless card.
2. Install the HDD and ODD cage.
3. Install the 3.5-inch hard drive.
4. Install the front cover.
5. Install the left-side cover.
6. Follow the procedure in After working inside your computer.
Media-card reader (optional)
Removing the media-card reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the front cover.
4. Remove the 3.5-inch drive.
5. Remove the HDD and ODD cage.
About this task
The following image(s) indicate the location of the media-card reader and provides a visual representation of the removal
procedure.
36
Removing and installing components