Dell Vostro 3710 - Removing the M.2 2280 Solid-State Drive; Installing the M.2 2280 Solid-State Drive

Next steps
1. Install the HDD and ODD cage.
2. Install the 3.5-inch hard drive.
3. Install the front cover.
4. Install the left-side cover.
5. Follow the procedure in After working inside your computer.
Removing the M.2 2280 solid-state drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the front cover.
4. Remove the 3.5-inch hard drive.
5. Remove the HDD and ODD cage.
About this task
The following image(s) indicate the location of the M.2 2280 solid-state drive and provides a visual representation of the
removal procedure.
Steps
1. Remove the screw (M2x3) that secures the solid-state drive to the system board.
2. Slide and lift the solid-state drive from the M.2 card slot on the system board.
Installing the M.2 2280 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
Removing and installing components
29