Steps
1. Align the fan shroud over the processor fan such that one side of the fan is facing the rear of the chassis. This side of the
fan shroud has the word "REAR" etched into it.
2. Position the fan shroud over the processor fan such that all the stubs on the shroud are aligned to the corresponding stub
holes on the processor fan.
3. Press down on the fan shroud until all the securing tabs have snapped into their positions.
4. Place the computer in an upright position.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
Processor fan and heat-sink assembly
Removing the fan and heat-sink assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the fan shroud.
About this task
The following image(s) indicate the location of the fan and heat-sink assembly and provides a visual representation of the
removal procedure.
Removing and installing components
43
To Next Page
Loading...
