Steps
1. Place the computer on its side with the left side facing up.
2. Slide the power-button cable through the slot on the front of the chassis.
3. Press the tabs on the power button, insert it through the slot on the chassis, and secure it into place on the chassis.
4. Connect the power-button cable to the system board.
5. Place the computer in an upright position.
Next steps
1. Install the HDD and ODD cage.
2. Install the 3.5-inch hard drive.
3. Install the front cover.
4. Install the left-side cover.
5. Follow the procedure in After working inside your computer.
Memory
Removing the memory
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the front cover.
4. Remove the 3.5-inch hard drive.
5. Remove the HDD and ODD cage.
About this task
The following image(s) indicate the location of the memory and provides a visual representation of the removal procedure.
Removing and installing components
25
To Next Page
Loading...
