Steps
1. Place and slide the media-card reader onto its slot on the system board.
2. Align the screw hole on the media-card reader bracket with the screw holes on the system board and the chassis.
3. Replace the two screws (M3x5) that secure the media-card reader bracket to the system board and the chassis.
Next steps
1. Install the 3.5-inch drive.
2. Install the HDD and ODD cage.
3. Install the front cover.
4. Install the left-side cover.
5. Follow the procedure in After working inside your computer.
Power-supply unit
Removing the power supply
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the front cover.
4. Remove the 3.5-inch hard drive.
5. Remove the HDD and ODD cage.
About this task
The following image(s) indicate the location of the power supply and provides a visual representation of the removal procedure.
38
Removing and installing components
To Next Page
Loading...
