Installing the base cover
1 Align the base cover with the screw holders on the computer.
2 Press the edges of the cover until it clicks into place.
3 Tighten the three M2.5 x 7 screws.
4 Replace the seven M2.5 x 4 screws to secure the base cover to the computer.
5 Follow the procedure in After working inside your computer.
Battery
Removing the battery
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 To remove the battery:
a Disconnect the battery cable [1] from the connector on the system board.
b Unroute the speaker cable [2].
10
Removing and installing components
To Next Page
Loading...
