d Remove the three M2.0 x 2 screws that secure the touchpad support bracket to the system and lift the touchpad away from
system [1, 2].
Installing touchpad
1 Replace the three screws to secure the touchpad support bracket to the system.
2 Connect the touchpad cable to the connector in the system.
3 Replace the four screws to secure the touchpad to the system.
4 Paste the adhesive to the touchpad.
5 Install the:
a battery
b base cover
6 Follow the procedure in After working inside your computer.
Display assembly
Removing display assembly
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b WLAN card
3 To remove the display assembly:
a Unroute the WLAN cable [1], and disconnect the eDP cable from the connector in the system board [2].
Removing and installing components
25
To Next Page
Loading...
