Installing the M.2 Solid State Drive — SSD
1 Align the notch on the solid-state drive with the tab on the solid-state drive slot.
2 Slide the solid-state drive into the slot.
3 Replace the M2.0 x 3 screw to secure the SSD to the system.
4 Install the base cover.
5 Follow the procedure in After working inside your computer.
WLAN card
Removing the WLAN card
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 To remove the WLAN card:
a Remove the M2.0 x 3 screw that secures the WLAN card to the system [1].
b Remove the tab that secures the WLAN cables [2].
c Disconnect the WLAN antenna cables from the WLAN card [3].
d Lift the WLAN card away from the connector [4].
Removing and installing components
15
To Next Page
Loading...
