Installing the coin cell battery
1 Place the coin cell battery into the slot on the system board.
2 Connect the coin cell battery cable to the connector on the system board.
3 Install the base cover.
4 Follow the procedure in After working inside your computer.
Solid State Drive — optional
Removing the M.2 Solid-State Drive — SSD
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 To remove the solid-state drive (SSD):
a Remove the M2.0 x 3 screw that secure the SSD to the system [1].
b Lift and slide the SSD away from the system [2].
14
Removing and installing components
To Next Page
Loading...
