Replacing the base cover
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1 Place the base cover on the palm-rest assembly and snap it into place.
2 Replace the 10 screws (M2x3 T5) that secure the base cover to the palm-rest assembly.
3 Replace the two screws (M2x8) that secure the base cover to the palm-rest assembly.
4 Turn the system badge over, and snap it into place.
5 Turn the computer over.
4
14 Replacing the base cover
To Next Page
Loading...
