Replacing the keyboard
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1 Place the keyboard on the palm-rest assembly
2 Align the screw holes on the keyboard with the screw holes on the palm-rest assembly.
3 Replace the 31 screws (M1.6x1.5) that secure the keyboard to the palm-rest assembly.
4 Adhere the Mylar that secures the keyboard to the palm-rest assembly.
5 Connect the keyboard cable and keyboard-backlight cable to the keyboard-controls board and close the latch to secure the cable.
6 Adhere the Mylar that secures the keyboard to the palm-rest assembly.
7 Adhere the tape that secures the ngerprint-reader cable to the palm-rest assembly.
Post-requisites
1 Replace the system-board assembly.
2 Follow the procedure from step 3 to step 6 in “Replacing the hard drive”.
3 Replace the battery (half-length) or the battery (full-length).
4 Replace the base cover.
32
Replacing the keyboard 59
To Next Page
Loading...
