Dell XPS 15-9570 - 24 Replacing the Heat Sink; Procedure; Post-Requisites

Replacing the heat sink
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
CAUTION: Incorrect alignment of the heat sink can damage the system board and processor.
NOTE: If either the system board or the heat sink is replaced, use the thermal pad provided in the kit to ensure that thermal
conductivity is achieved.
Topics:
• Procedure
• Post-requisites
Procedure
1 Align the screw holes on the heat sink with the screw holes on the system board.
2 Replace the ve screws (M2x3) that secure the heat sink to the system board.
NOTE
: Depending on the conguration ordered, some congurations may have four screws
(M2x3).
Post-requisites
1 Replace the battery (half-length) or the battery (full-length).
2 Replace the base cover.
24
46 Replacing the heat sink