Replacing the power-adapter port
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1 Place the power-adapter port into the slot on the palm-rest assembly.
2 Route the power-adapter port cable through its routing guides on the palm-rest assembly.
3 Replace the screw (M2x3) that secures the power-adapter port to the palm-rest assembly.
4 Connect the power-adapter port cable to the system board.
Post-requisites
1 Replace the display assembly.
2 Replace the battery (half-length) or the battery (full-length).
3 Replace the base cover.
40
72 Replacing the power-adapter port
To Next Page
Loading...
