Removing the battery (half-length)
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
Remove the base cover.
Procedure
1 Remove the four screws (M2x4) that secure the battery to the palm-rest assembly.
2 Disconnect the battery cable from the system board.
3 Lift the battery o the palm-rest assembly.
Figure 3. Removing the battery
1
battery cable 2 screws (4)
3 battery 4 palm-rest assembly
4 Turn the computer over, open the display, and press the power button for ve seconds to ground the system board.
5
Removing the battery (half-length) 15
To Next Page
Loading...
