Dell XPS 15-9570 - 15 Removing the Solid-State Drive (Full-Length); Prerequisites; Procedure

Removing the solid-state drive (full-length)
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
1 Remove the base cover.
2 Remove the battery (half-length) or the battery (full-length).
Procedure
1 Remove the screw (M2x3) that secures the solid-state drive to the system board.
2 Lift and slide the solid-state drive assembly from the system board.
Figure 13. Removing the solid-state drive
1
screw 2 thermal pad
15
30 Removing the solid-state drive (full-length)