Figure 18. Removing the right fan
1
tape 2 touch-screen cable (optional)
3 fan cable (JFAN2) 4 right fan
5 screws (2)
7 Remove the two screws (M2x4) that secure the display-cable bracket to the system-board assembly.
Figure 19. Removing the display-cable bracket
1
display-cable bracket 2 screws (2)
8 Disconnect the display cable from the system-board assembly.
9 Note the routing of the display cable and remove the cable from the routing guides on the left fan.
10 Peel oî the tape that secures the display cable to the system-board assembly.
11 Disconnect the left fan cable (JFAN1) from the system-board assembly.
Removing the fans
41
To Next Page
Loading...
