Figure 29. Disconnecting the cables
1 routing guides 2 tape (display cable)
3 tapes (touch-screen cable) 4 touch-screen cable (optional)
5 tape 6 screws (2)
7 display-cable bracket 8 display cable
7 Turn the computer over and open the display at an angle of 90 degrees.
8 Rotate the computer and place it on the edge of the table in a position that allows access to the screws on the display hinges.
9 Remove the six screws (M2.5x5) that secure the display hinges to the palm-rest assembly.
10 Carefully lift the display assembly from the palm-rest assembly.
Removing the display assembly
67
To Next Page
Loading...
