Chapter 7 Servo Parameters|ASDA-AB Series
Revision January 2009 7-85
P4 - 12 SOF2 Analog Speed Input Drift Adjustment 2 Communication Addr.: 040CH
Default: Factory setting Related Section: N/A
Applicable Control Mode: ALL
Unit: N/A
Range: 0~32767
Settings:
Please see P4-11 for explanation.
P4 - 13 TOF1 Analog Torque Drift Adjustment 1 Communication Addr.: 040DH
Default: Factory setting Related Section: N/A
Applicable Control Mode: ALL
Unit: N/A
Range: 0~32767
Settings:
This adjustment function is enabled after parameter P2-08 is set to 22. This is an auxiliary
adjusting function, although this parameter allows the users can execute manual adjustment, we
still do not recommend the users to change the default setting manually.
This parameter cannot be reset.
P4 - 14 TOF2 Analog Torque Drift Adjustment 2 Communication Addr.: 040EH
Default: Factory setting Related Section: N/A
Applicable Control Mode: ALL
Unit: N/A
Range: 0~32767
Settings:
Please see P4-13 for explanation.
P4 - 15 COF1 Current Detector Drift Adjustment (V1 phase) Communication Addr.: 040FH
Default: Factory setting Related Section: N/A
Applicable Control Mode: ALL
Unit: N/A
Range: 0~32767
Settings:
This adjustment function is enabled after parameter P2-08 is set to 22. This is an auxiliary
adjusting function, although this parameter allows the users can execute manual adjustment, we
still do not recommend the users to change the default setting manually.
This parameter cannot be reset.
To Next Page
Loading...
