Delta 32-100 - Starting and Stopping Machine.11; Locking Switch in the OFF Position.11

ADJUSTING TABLE
90 DEGREES TO FENCE
1. L oosen table lock handle (A) Fig. 23, make sure the
table is all the way down and tighten lock handle (A).
2. U sing a square (B) Fig. 23, check to see if the table
is 90 degrees to the fence, as shown.
3. I f the table is not at 90 degrees to the fence, adjust
the table accordingly making certain screw (C) Fig. 24,
contacts bottom of table when the table is at 90 degrees
to the fence. Screw (C) can be adjusted by loosening nut
(D), turning screw (C) in or out the desired amount and
tightening nut (D). This positive stop enables you to rapidly
return the table to the 90 degree position after it has
been tilted.
STARTING AND
STOPPING MACHINE
The on/off switch (A) Fig. 25, is located on the side of the
motor. To turn the plate joiner “ON,” move the toggle
switch (A) toward the front. To turn the machine off, push
the switch (A) toward the rear.
LOCKING SWITCH IN
THE “OFF” POSITION
We suggest when the machine is not in use, the switch
(A) be locked in the “OFF” position with a padlock, as
shown in Fig. 26.