Delta 32-100 - Dual Position Vt;Ork Clamp.8; Dust Chute.8; Fastening Machine to Supporting Surface.8

DUAL POSITION
WORK CLAMP
The dual position work clamp can be used in the vertical
position, as shown in Fig. 15, or in the horizontal position,
as shown in Fig. 16.
To instantly position the clamp (A) Fig. 15 and Fig. 16,
against the workpiece, simply turn the handle (B) counter¬
clockwise one-half turn and rapidly slide the threaded shaft
(C) until the clamp (A) is against the work. Then tighten
the clamp (A) by turning the handle (B) clockwise.
DUST CHUTE
A dust chute (A) is supplied for use with your plate joiner
and is to be assembled to the chip exhaust (B) on the left
rear side of the machine, as shown in Fig. 17. The plate
joiner can be connected directly to the Delta accessory
49-255 28-gallon, all purpose vacuum cleaner by removing
the dust chute (A) Fig. 17, and using the accessory 49-220
{2V2" X IV 2 " ) adapter and the accessory 49-228 ( 2 V 2 " x
2 V 2 " ) coupling. The hose from the 49-255 vacuum cleaner
can then be connected to the coupling.
Fig. 17
FASTENING MACHINE TO SUPPORTING SURFACE
The plate joiner must always be fastened to a supporting
surface using clamps or by using bolts through the four
mounting holes in the machine base. Two of the mount¬
ing bolts are shown at (A) Fig. 18.
8
Fig. 18