Delta 32-100 - Additional Safety Rules for Plate Joiner.4; Assembly Instructions; Assembling Table.4

ADDITIONAL SAFETY RULES
FOR PLATE JOINER
1. WARNING: Do not operate your machine until it is
completely assembled and installed according to the
instructions.
2. IF YOU ARE NOT thoroughly familiar with the opera¬
tion of Plate Joiners, obtain advice from your supervisor,
instructor or other qualified person.
3. MAKE CERTAIN that machine is securely attached
to support table before operating.
4. CHECK to make sure that cutter blade is securely
fastened.
5. KEEP fingers out of path of cutting blade.
6. USE the adjustable stock stop and dual positon work
clamp provided to properly secure and control workpiece
whenever possible.
7. ALWAYS wear eye protection
8. NEVER reach behind or over cutting tool with either
hand for any reason.
9. PROVIDE adequate support to the rear and sides of
the work support table for wide or long workpieces.
10. AVOID operations and hand positions where a
sudden siip could cause your hand to move into the cutting
tool.
11. NEVER perform layout, assembly or set-up work on
the table while the machine is operating.
12. ALWAYS turn the machine “OFF” and disconnect
the cord from the power source before installing or re¬
moving the blade.
13. NEVER leave the machine work area when the
power is “ON” or before the machine has come to a com¬
plete stop.
ASSEMBLY INSTRUCTIONS
ASSEMBLING TABLE
1. Place the motor and fence assembly (A) Fig. 2, on a
flat supporting surface or workbench, as shown.
2. Position table (B) Fig. 2, so guide (C) will rest inside
channel (D) of fence.
Fig. 2
4