Delta 32-100 - Assembling Micro-Set Table Adjuster.6; Positioning Safety Guard on Foot Pedal.6

ASSEMBLING MICRO-SET
TABLE ADJUSTER
1. M ake sure top of screw (A) Fig. 6, is engaged with
bracket (B) and insert bracket assembly (C) in channel (D).
Fasten bracket assembly (C) to fence (E) using screw (F)
and washer (G). Do not tighten screw (F). Turn knob (H)
until bracket (C) is down as far as possible in channel (D)
and tighten screw (F).
2. F ig. 7, illustrates the micro-set table adjuster correctly
assembled to the table and fence.
3. Position machine so it rests over edge of the support¬
ing surface, as shown in Fig. 8.
4. IMPORTANT; TO AVOID PERSONAL INJURY OR
DAMAGE TO THE MACHINE, WE STRONGLY SUG¬
GEST THAT THE MACHINE BE FASTENED TO THE
SUPPORTING SURFACE DURING THE REST OF THE
ASSEMBLY PROCEDURE USING CLAMPS OR
FASTENERS.
POSITIONING SAFETY
GUARD ON FOOT PEDAL
1. Lift up and rotate guard (A) Fig. 9, until hole in guard
lines up with hole (B) in foot pedal assembly. Fasten guard
(A) in place with lockwasher (C) and threaded lock knob
(D).
6
Fig. 9