Chapter 3 Product Specifications
3-13
The user-defined input device range: D60~D75
Motion Control Modules
You can assign input registers and output registers to a motion control module through HWCONFIG in ISPSoft. The
input registers should be within the range between D0 and D65535, and the output registers should be within the
range between D0 and D65535. Take AH04HC-5A for example. The original input registers are D0~D27. You can
change the input device range from D0~D27 to D200~D227.
The default input device range: D0~D27
The user-defined input device range: D200~D227
Network Modules
You can assign input registers and output registers to a network module through HWCONFIG in ISPSoft. The input
registers should be within the range between D0 and D65535, and the output registers should be within the range
between D0 and D65535. Take AH10EN-5A* for example. The original input registers are D0~D19. You can change
the input device range from D0~D19 to D150~D169.
*Note: The diagram below is only a demonstration on changing input device range.
To Next Page
Loading...
