Delta ASD-A2R-0421 Series - Page 254

Chapter 8 ParametersASDA-A2R Series
8-22 Revision December, 2014
NOTE
Please refer to parameter P1-04, P1-05 for proportional
setting of analog output voltage.
For example: P0-03 = 01 (MON1 is the analog output of motor
speed; MON2 is the anlog output of motor torque (force))
(unit：Volts)
(unit: Volts)
P0-04■
Reserved
Address: 0008H
0009H
P0-05■
Reserved
Address: 000AH
000BH
P0-06■
Reserved
Address: 000CH
000DH
P0-07■
Reserved
Address: 000EH
000FH
P0-08★
TSON Power On Time
Address: 0010H
0011H
Operational
Interface：
Panel / Software Communication
Related Section：-
Default：
0
Control
Mode：
-
Unit：
Hour
Range：
0 ~ 65535
Data Size：
16bit
Format：
DEC
Settings：
It shows the total startup time of the servo drive.
P0-09★
CM1 Status Monitor Register 1
Address: 0012H
0013H
Operational
Interface：
Panel / Software Communication
Related Section:
4.3.5
Default：
-