Delta ASDA-M Series User Manual

Chapter 5 Trial Operation and Tuning ASDA-M
5-16 Revision December, 2014
Note:
1. If P2-33 bit 0 is set to 1, it means the inertia estimation in semi-auto mode is
completed. The result can be accessed by P1-37.
2. If the value of P2-33 bit 0 is cleared to 0, the system will start to estimate again.

Delta ASDA-M Series Specifications

General

Brand	Delta
Model	ASDA-M Series
Category	Servo Drives
Language	English