Chapter 7 Motion Control ASDA-M
7-2 Revision December, 2014
variables to system parameters.
Mapping
Support
8 groups of parameter, P0-25
~ P0-32
(set by P0-35 ~ P0-42)
5 groups of parameter, P0-09 ~ P0-13
(set by P0-17 ~ P0-21)
Note
In Monitor Mode, pressing UP/DOWN
Key on the panel to switch the
commonly used monitor variables
(code 0~26); however, it cannot
display all (about 150 in total)
To Next Page
Loading...
