Delta ASDA-M Series

ASDA-M Chapter 8 Parameters
Revision December, 2014 8-29
P0-31 MAP7 Mapping Parameter # 7
Address: 003EH
003FH
Parameter
Attribute：
Parameter for individual axis
Related Section:
Section 4.3.5
Operational
Interface：
Panel / Software Communication
Default：
No need to initialize
Control
Mode：
ALL
Unit：
-
Range：
determined by the corresponding
parameter of P0-41
Data Size：
32bit
Format：
HEX
Settings：
The using method is the same as P0-25. The mapping target is
set by parameter P0-41.
P0-32 MAP8 Mapping Parameter # 8
Address: 0040H
0041H
Parameter
Attribute：
Parameter for individual axis
Related Section:
Section 4.3.5
Operational
Interface：
Panel / Software Communication
Default：
No need to initialize
Control
Mode：
ALL
Unit：
-
Range：
determined by the corresponding
parameter of P0-42
Data Size：
32bit
Format：
HEX
Settings：
The using method is the same as P0-25. The mapping target is
set by parameter P0-42.
P0-33 Reserved
Address: 0042H
0043H
P0-34 Reserved
Address: 0044H
0045H